• Order Form

    This form is for compression springs only. Any other springs will require a drawing.

    "*" indicates required fields

    Specifications

    For recommended materials and sizing, check out our material data here.
    Spring

    Type Ends

    Type Ends
    Counting Coils

    Counting Coils

    Count along the spring in complete revolutions. Each complete revolution is considered one full coil. If the spring does not end on a full coil, as in the figure on the left, the remainder can be expressed as a fraction of a coil. Adding the fraction of coil to the number of full coils counted gives the total number of coils, 5.5 in the example

    Right Hand Wind vs. Left Hand Wind

    If the index finger of the right hand can be bent to simulate dirction of coil, so that the fingernail and coil tip are approximately at the same angular position, the spring is right-hand wound, as depicted in the right pane of the figure below. If the index finger of the left hand simulates the coil direction, the spring is left-hand wound, as shown in the left pane of the figure below. If direction of coiling is not critical, optional winding should be specified.

    Right Hand Wind vs. Left Hand Wind
    Wind
    Preset

  • Upload Drawing

    "*" indicates required fields

    Name*
    Rush Order?*
    Max. file size: 64 MB.